Pulley Blocks
Consists of free running, well balanced plastic pulleys. Each pulley measures 5 cm dia. and is mounted in an alloy frame
with hook at each end.
 
-01 Single Pulley
-02 Double Pulley
-03 Triple Pulley
-04 Quadruple Pulley
 
Tandem Pulleys
These tandem pulleys are very long-lasting. They are provided with pin bearings and hooks on the top and bottom for hanging.
 
-01 Double Pulley (3.8cm and 5cm dia.)
-02 Triple Pulley (2.5cm, 3.8cm and 5cm dia.)
 
Rod Mounted Pulley
Suitable for use with ordinary laboratory apparatus. Plastic pulley of dia 3.8cm dia, mounted on a metal rod. Overall length is about 17.5cm.
 
Rod Mounting, Bench Fit, Pulley
This 70mm dia. Pulley on a metal clamp, holds firmly in either a vertical or horizontal position. The bracket can be clamped to a bench edge of thickness 38mm.
 
Wheel on Axis
Ball bearing, four coaxial pulley mounted on a single steel rod.
Can be attached to any right-angle clamp.
 
Linear Air Track Kit

Suitable for study of linear motion under nearly frictionless conditions. The kit consists of square section aluminium track, length 1.5m, with two rows of fine holes along the top. Supported on two light alloy castings. One support has a two point contact and other a one point contact for lateral and orizontal adjustments by means of a knurled screw. One end of the section is fitted with a tube for connection to blower and the other end is closed.

Comes complete with following accessories:
» 2 heavy and 1 light vehicle with their mass ratio 2:1.
» 2 Magnetic buffers
» 2 Plasticine Holders with central hole
» 4 Catapults with slots for elastic band
» 1 Reel of nylon thread
» 2 White rods(4 mm diam.150 mm long)
» 24 Needles
» 20 Black plain cards
» 1 Pack of plasticine
» 20 Elastic bands
» 1 Instruction manual
 
 

[ Email : info@ambalalab.com ]