It is closed circuit test rig consists of “ ISI mark “ monoblock centrifugal pump. The pump is provided with a vaccum gauge on suction pipe and a pressure gauge on discharge pipe. The gate valve is used to adjust the head on the pump. The discharge is measured by measuring tank / water flow meter. The input power is measured by energymeter.

SPECIFICATIONS:-

1) Centrifugal Multistage Monoblock – 5 H.P.
2) Pressure Gauge and Vaccum Gauge for measuring the head.
3) Measuring tank of sufficient capacity.
OR
4) Water flow energy meter for measuring discharge.
5) Stop watch.
6) Sump Tank of sufficient capacity.
7) Energymeter to measure input power.

SERVICES REQUIRED :-
1) 440 V 15 Amp. ,stabilised three phase A.C.Supply
2) Floor Area – 2m x 2m x 1.5m height.
3) Tachometer for speed measurement ( can supplied at extra cost )

A technical Mannul accompanies the unit.
 

The close circit test rig consists ot reciprocating pump connected to D.C. motor controlled with the help of a dimmerstat. The pump is provided with a vaccum gauge on suction pipe and a pressure gauge on discharge pipe. The gate valve is used to adjust the head on the pump. The discharge is measured by measuring tank / water flow meter. The input power is measured by energymeter.

SPECIFICATIONS:-

1) Reciprocating pump driven by D.C.Motor –1 H.P.
2) Pressure Gauge and Vaccum Gauge for measuring the head.
3) Measuring tank of sufficient capacity.
OR
Water flow energy meter for measuring discharge.
4) Stop watch.
5) Sump Tank of sufficient capacity.
6) Energy meter to measure input power.

FEATURES :-

1) The equipment is coated with an attractive and anticorosive powder coating
2) The equipment consists of ISI standards of Energy meter & Water flow meter.

SERVICES REQUIRED :-
1) 220 V 15 Amp. ,stabilised three phase A.C.Supply
2) Floor Area – 2m x 2m x 1.5m height.
3)Tachometer for speed measurement ( can supplied at extra cost )

A technical Mannul accompanies the unit.

The close circit test rig consists ot reciprocating pump connected to A.C. motor with the help of a stepped cone pulley. Adjusting the belt on another pulley can change the speed of the pump. The pump is provided with a vaccum gauge on suction pipe and a pressure gauge on discharge pipe. The gate valve is used to adjust the head on the pump. The discharge is measured by measuring tank / water flow meter. The input power is measured by energymeter.

SPECIFICATIONS:-

1) Reciprocating pump driven by A.C.Motor –1 H.P.
2) Pressure Gauge and Vaccum Gauge for measuring the head.
3) Measuring tank of sufficient capacity.
OR
Water flow energy meter for measuring discharge.
4) Stop watch.
5) Sump Tank of sufficient capacity.
6) Energy meter to measure input power.

FEATURES :-

7) The equipment is coated with an attractive and anticorosive powder coating
8) The equipment consists of ISI standards of
a. Energy meter
b. Water flow meter.

SERVICES REQUIRED :-
1) 220 V 15 Amp. ,stabilised three phase A.C.Supply
2) Floor Area – 2m x 2m x 1.5m height.
3)Tachometer for speed measurement ( can supplied at extra cost )

A technical Mannul accompanies the unit